We
use only the best vinyl that is available to
cut our decals from. Each high performance decal
can be mass produced with a repeated accuracy
of .005 of an inch.Decals
can be installed easily by yourself using either
of these methods.
Small
Decal Dry Hinge Application
Click
here for pictures of application
_______________________________________________________
Wet
Method
( Allows moving the decal around on surface.
)
Click here for
pictures of
the application process.
1
- Clean Surface
2
- Spray surface with JET application fluid.
3
- Remove the hard backing paper from decal.
4
- Apply to surface, align and squeegee from
center out.
5
- Allow to dry for 1 - 30 minutes until decals
is thoroughly adhered then spray the release
paper with application fluid and squeegee.
6
- Remove release paper slowly at a 45 degree
angle from top corner pulling it 180 degrees
to the other side so it does not lift the decal.
7
- Dab decal dry with paper towel or soft cloth
( Do not wipe or it may pull up edges) allow
to dry 2 days before washing or waxing.
Application
Videos
For
an application diagram click
here
Dry
Hinge Method Multiple Letters
Click
here for pictures of the application process.
1
- Place decal on surface align and apply masking
tape across the bottom.
2
- Allow decal to hinge downward and remove hard
backing paper.
3
- Carefully squeegee starting at the tape hinge
from bottom center outward moving up an inch
at a time while holding the top of the decal
away from the surface.
4
- Remove
release paper slowly at a 45 degree angle from
top corner pulling it 180 degrees to the other
side so it does not lift the decal.
Application
Videos
For
an application diagram click
here
Applying Other Types of Decals
Flames
Toe Nails
