How to Put on Decal Flames

1. 1

   Clean the area where you want to put the decal. Use a bucket of soapy, warm water and clean all surface gunk off surface. This will prevent anything getting in the way of the decal sticking to the car.

2. 2

   Cut off section of decal to apply. Measure the sticker and tape the top corners of decal to surface to hold it in place.

3. Place a long piece of tape along bottom to create a hinge and remove small pieces of tape.
4. 3

   Fold decal down using tape hinge and peel the paper backing off the sticker without pulling the decal off the soft sticky transfer paper. Hang onto the decal transfer paper so it doesn't stick to the car or anything else before you are ready to apply it.

5. 4

   Start rubbing from the bottom center out and up using a credit card or squeeggee. Work from the middle out. Rub decal to remove any air pockets.

6. 5

   Let the sticker set up for a few minutes, then peel the transfer tape off, starting at one corner pulling on a 180 degree angle. Make sure decal stays stuck to surface as you pull slowly. Reapply if it pulls away and repeat.